哪个电路板套件能够控制开发的燃烧器

嗨，我想控制开发的燃烧器，请告知我，这板附近matchmy要求。！
我想控制的压力和温度传感器和3台燃烧器火焰燃烧器的工作上。一：系统启动（控制：监控传感器的压力和温度）：预热塞12v 17a（控制：打开/关闭定时器+温度传感器）：风机12v 11a，（控制：开/关+ PWM调速+温度传感器：燃油泵12V，4A，PWM开关（控制：开/关+可变速度开关D +温度传感器燃烧器系统启动时所需的压力和温度将达到的水平。1st辉光插头会在产生火焰，2nd鼓风机将在低流量，3rd燃油泵将用于产生连续的火焰，一：单片机32bit Cortex M4 200mhz 2:闪存2mb +加速器三：内存512四：2u*** +2五：以太网IEEE1588六：ADC 8 7：开/关六mofsets功率：温度传感器6 9：P压力传感器6 10：JTAG头11：TFT控制器+液晶10：I / O 20 11：多功能报警4个+ RTC 12：PWM 8
等待您的帮助答复。问候安德烈·萨米



     以下为原文
  Hi,

I want to develop control unit for burner,  kindly advise me, which board kit is near to match my requirements .!
     
    I want to control burner flame with pressure and temperature sensors and three units are attached with burner working.

1: System start up with ( control : Monitor pressure and Temp by sensors )
2: Glow Plug 12v 17A (control : switch on/off with timer + Temp sensor )
3: Blower fan 12V 11A, ( Control : switch on/off + PWM variable speed + temp sensor
4: Fuel Pump 12V, 4A, PWM ( Control : Switch on/off + variable speed + temp sensor

Burner system will start up when Pressure and Temp will reached at desired level.
1st glow plug will on for produce flame , 2nd blower will on with low flow, 3rd fuel pump will on for produce continuous flame,


1: MCU 32Bit Cortex M4 200Mhz
2: Flash 2mb + Accelerator
3: Ram 512
4: 2USB + 2 CAN
5: Ethernet IEEE 1588
6: ADC 8
7: Power on/off 6 Mofsets
8: Temperature Sensor 6
9: Pressure Sensor 6
10: Jtag header
11: TFT controller + LCD
10: I/O 20
11: Multi Function AlARMs 4 +RTC
12: PWM 8
     
    Awaiting your helpful reply.

Regards
Sami